Installation steps of light stainless steel roller conveyor

The installation of the stainless steel roller conveyor is extremely important. It is directly related to the conveying efficiency of the belt conveyor. Long-term use of the machine may also affect the service life of the stainless steel roller conveyor. The stainless steel roller conveyor can not only convey materials by a single machine, but also cooperate with other conveying materials to form a rhythmic flow-through transportation line.

Today, I will tell you the installation steps of the light stainless steel roller conveyor, which can be divided into 4 steps:

1. Install the frame of the light stainless steel roller conveyor

Since the frame is divided into a head frame, a middle frame and a tail frame, we also have an order during installation. The head frame is installed first, then the middle frame is installed and the tail frame is the last. Before installing the rack, we must first draw the center over the entire length of the conveyor. Because keeping the center line of the conveyor in a straight line is an important condition for the normal operation of the conveyor belt, so when installing each section of the rack, Align the center line, and at the same time set up a rack to level it. The allowable error of the rack to the center line is ±0.1mm per meter. However, the error of the center of the frame over the overall length of the conveyor shall not exceed 35mm. After all the single sections are installed and identified, the single sections can be connected.

2. Install the drive device

When installing the drive device, care must be taken to make the drive shaft of the light stainless steel roller conveyor perpendicular to the center line of the light stainless steel roller conveyor, so that the center of the drive roller width coincides with the center line of the conveyor, and the axis of the reducer is parallel to the drive axis . At the same time, all shafts and rollers should be leveled. The horizontal error of the shaft is allowed within the range of 0.5-1.5mm according to the width of the conveyor. While installing the drive device, you can install the tail wheel and other tensioning devices. The roller axis of the tensioning device should be perpendicular to the center line of the light stainless steel roller conveyor.

3. Install the roller

After the frame, transmission device and tensioning device are installed, the roller racks of the upper and lower rollers can be installed, so that the conveyor belt has a curved arc that changes slowly. The distance between the roller racks in the turning section is 1 of the normal roller rack spacing. /2～1/3. After the roller is installed, make its rotation flexible and brisk.

4. Identify

Ensure that the conveyor belt always runs on the center line of the idler and drum.

MAILONG MACHINERY can not only provide you with roller conveyors, we also customize Curve Conveyor, Chain Conveyor and other conveyor rollers. Please consult us if you have any needs.